Horstronic Waveslicer
PCB/Panel Set
The Waveslicer is a special waveshaper. It can cut a wave into slices and move those slices up and down.
It simply does that by adding an offset at a defined point of the wave. This point is the threshold, set by the Pulsewidth pot. The amplitude of the offset is set by the Amount pot.
To make it all a bit more interesting, this is all done twice at the same time, so there are actually two waveslicers working in parallel.
Also, every described parameter is fully voltage controllable.
The maximum threshold of both sections can be altered by the Range pot.
This module is designed as an audio waveshaper but it's DC coupled, so you can also use it for CVs. This can be a lot of fun, for example when mangling LFOs.
Both sections of the waveslicers also have an Offset pot. This can add an offset to the incoming signal before it goes into the comparators.
BOM/Build doc
